Lenze ECSCExxx Power supply module - Manual (Page 138)

Appendix
Codes
12
l
138 EDBCSXE040 EN 7.0
Parameter
C0356
Name
CAN time settings
Data type: INTEGER_32
Index: 24219 dec = 5E9B hex
Setting of the ...
l Boot−up time
l Cycle time
l Activation delay
^ 90
Setting range
(min. value | unit | max. value)
0 ms 65000
Subcodes Lenze setting Information
C0356/1 3000 ms CAN boot−up time
l Delay time after mains connection for the
initialisation by the master.
l Only valid if C0352 = 1 (master).
C0356/2 0 ms Cycle time for CAN2_OUT
l Diagnostics PDO C0390 ( ^ 98)
C0356/3 0 ms Cycle time for CAN3_OUT
l Factor to task time for process data telegram
transmission.
l 0 ms = event−controlled data transmission (the
output data will only be transmitted if a value
changes in the output object)
C0356/4 20 ms Delay time for initial transmission of the process data
object CAN3_OUT after the CAN bus changes to
"Operational"
Parameter
C0357
Designation
CAN_IN monitoring times (CE1 ... CE3)
Data type: INTEGER_32
Index: 24218
dec
= 5E9A
hex
Monitoring times for process data input objects
l If no telegram arrives within the time set, CE1 ... CE3−TRIP is enabled.
l Setting "0 ms" = monitoring is switched off
^ 108
Setting range
(min. value | unit | max. value)
0 ms 65000
Subcodes Lenze setting Information
C0356/1 0 ms CAN1_IN monitoring time CE1
(cyclic operation (sync−controlled))
C0356/2 0 ms CAN2_IN monitoring time CE2
(reserved)
C0356/3 0 ms CAN3_IN monitoring time CE3
(event−controlled/cyclic operation without sync)
Parameter
C0358
Designation
CAN reset node
Data type: INTEGER_32
Index: 24217 dec = 5E99 hex
Make a reset node for the CAN bus node.
^ 94
Selection list
(Lenze setting printed in bold) Information
0 No function
1 CAN reset