Lenze ECSCExxx Power supply module - Manual (Page 134)

Appendix
Codes
12
l
134 EDBCSXE040 EN 7.0
Parameter
C0173
Designation
Mains voltage selection
Data type: INTEGER_32
Index: 24402
dec
= 5F52
hex
Mains voltage selection
^ 67
Selection list
(Lenze setting printed in bold) Information
No response
0 Operation on 230 V mains
1 Operation on 400 V mains
2 Operation on 460 V mains
3 Operation on 480 V mains
4 Automatic determination
Parameter
C0178
Designation
Elapsed−hour meter
Data type: INTEGER_32
Index: 24397 dec = 5F4D hex
Display of the time during which the power supply module was enabled.
Display range (min. value | unit | max. value)
−214748 h 214748
Parameter
C0179
Designation
Power−on time meter
Data type: INTEGER_32
Index: 24396
dec
= 5F4C
hex
Display of the time during which the DC bus was charged.
Display range (min. value | unit | max. value)
−214748 h 214748
Parameter
C0183
Designation
Module diagnostics
Data type: INTEGER_32
Index: 24392 dec = 5F48 hex
l Display of fault or status information.
l If several pieces of fault or status information are available at the same time, the information with the lowest
number is displayed.
Display list Information
0 No fault
101 Initialisation phase
102 TRIP is active
104 Message is active
142 Pulse inhibit (IMP) is active
250 Warning is active
Parameter
C0200
Designation
Firmware identification (ID)
Data type: VISIBLE_STRING
Index: 24375
dec
= 5F37
hex
Display of the firmware identification (ID)
Parameter
C0201
Designation
Firmware creation date
Data type: VISIBLE_STRING
Index: 24374
dec
= 5F36
hex
Display of the firmware creation date
Parameter
C0204
Designation
Device serial number
Data type: INTEGER_32
Index: 24371
dec
= 5F33
hex
Display of the device serial number