Rockwell Automation 22C PowerFlex 400 AC Drive FRN 1.xx - 7.xx - Manual (Page 103)

Programming and Parameters 3-45
PowerFlex 400 Adjustable Frequency AC Drive FRN 1.xx - 7.xx User Manual
Publication 22C-UM001I-EN-P
Advanced Program Group (continued)
A174 [Maximum Voltage] Related Parameter(s): b004 , A171 , A172 , A173
Sets the highest voltage the drive will output.
Values Default: Drive Rated Volts
Min/Max: 20/Drive Rated Volts
Display: 1 VAC
A175 [Slip Hertz @ FLA] Related Parameter(s): P033
Compensates for the inherent slip in an induction motor. This frequency is added to the commanded
output frequency based on motor current.
Values Default: 2.0 Hz
Min/Max: 0.0/10.0 Hz
Display: 0.1 Hz
A176 [DC Brake Time] Related Parameter(s): P037 , A177
Sets the length of time that DC brake current is “injected” into the motor when P037 [Stop Mode] is set
to either 4 “Ramp” or 6 “DC Brake”. Refer to parameter A177 [DC Brake Level].
Values Default: 0.0 Secs
Min/Max: 0.0/99.9 Secs (A setting of 99.9 = Continuous)
Display: 0.1 Secs
A177 [DC Brake Level] Related Parameter(s): P037 , T051 - T054 , A176 , A178
Defines the maximum DC brake current, in amps, applied to the motor.
Values Default: Drive Rated Amps
×
0.05
Min/Max: 0.0/(Drive Rated Amps
×
1.5)
Display: 0.1 Amps
DC Injection Braking Mode
V
olts/S
p
eed
Voltage
Time
Stop Command
Speed
[DC Brake Level]
[DC Brake Time]
V
olts/S
p
eed
Ramp-to-Stop Mode
Time
Stop Command
[DC Brake Level]
[DC Brake Time]
Voltage
Speed
ATTENTION: If a hazard of injury due to movement of equipment or material exists,
an auxiliary mechanical braking device must be used.
ATTENTION: This feature should not be used with synchronous or permanent
magnet motors. Motors may be demagnetized during braking.