Rockwell Automation 22C PowerFlex 400 AC Drive FRN 1.xx - 7.xx - Manual (Page 59)

PowerFlex 400 Adjustable Frequency AC Drive FRN 1.xx - 7.xx User Manual
Publication 22C-UM001I-EN-P
Chapter
3
Programming and Parameters
Chapter 3 provides a complete listing and description of the PowerFlex
400 parameters. Parameters are programmed (viewed/edited) using the
integral keypad. As an alternative, programming can also be performed
using DriveExplorer™ or DriveExecutive™ software, a personal
computer and a serial converter module. Refer to
Appendix B for catalog
numbers.
To configure a drive to operate in a specific way, drive parameters may
have to be set. Three types of parameters exist:
•
ENUM
ENUM parameters allow a selection from 2 or more items. Each item
is represented by a number.
•
Numeric Parameters
These parameters have a single numerical value (i.e. 0.1 Volts).
•
Bit Parameters
Bit parameters have four or more individual bits associated with
features or conditions. If the bit is 0, the feature is off or the
condition is false. If the bit is 1, the feature is on or the condition is
true.
Some parameters are marked as follows.
For information on… See page…
About Parameters 3-1
Parameter Organization 3-2
Basic Display Group 3-4
Basic Program Group 3-7
Terminal Block Group 3-12
Communications Group 3-31
Advanced Program Group 3-35
Aux Relay Card Group 3-55
Advanced Display Group 3-60
Parameter Cross-Reference – by Name 3-71
About Parameters
= Stop drive before changing this parameter.
= 32 bit parameter. Parameters marked 32 bit will have two
parameter numbers when using RS485 communications and
programming software.
32