Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start - Manual (Page 122)

122 Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013
Chapter 5 FactoryTalk View ME Configuration
Configure Parameter Files
Follow these steps to configure a parameter file for each device or logic module in your application supported by
a faceplate.
1. Right-click a parameter file for a device in your application and choose Rename.
2. Rename the parameter file with the name of the corresponding device in your Logix Designer application.
If more than one device uses the same faceplate then another parameter of the same type must be
duplicated and renamed. Refer to
step 4 and step 5 on page 112 .
For the Widg-O-Matic example, these are the parameter files:
3. Click OK.
Base Parameter File Name Widg-O-matic Parameter File Name
CIPMotion_Parameter
Gantry_X_Axis
Gantry_Y_Axis
PF_Parameter Conveyor_Drive
K300_Parameter Diverter_Drive
EquipmentStatus_Parameter EquipmentStatus
Startup_Parameter Startup
StateDiagram_Parameter StateDiagram