Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start - Manual (Page 125)

Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013 125
FactoryTalk View ME Configuration Chapter 5
a. Double-click the parameter file to open it.
b. Enter your application controller’s shortcut name in all
parameters.
c. Enter the associated faceplate AOI tag name of the device or
module for this faceplate parameter.
d. Close parameter file and acknowledge the Save Changes
dialog box.
9. Repeat step 8 for each of your device or module faceplate parameters.
For the Widg-O-Matic example, the parameters are edited as follows:
TIP Less editing is required when assigning HMI alarm tags if you name your controller shortcut [CLX]. Refer to Chapter 6 on
page 147 for configuring your controller shortcuts in RSLinx Enterprise communication setup.
Widg-O-Matic Parameter File Parameter File Configuration
Gantry_X_Axis
#1=::[CLX]
#2=::[CLX]Gantry_X_Axis_FP
Gantry_Y_Axis
#1=::[CLX]
#2=::[CLX]Gantry_Y_Axis_FP
Conveyor_Drive #1=::[CLX]Conveyor_Drive_FP
Diverter_Drive
#1=::[CLX]
#2=::[CLX]Diverter_Drive_FP
EquipmentStatus
#1=::[CLX]Gantry_X_Axis_FP
#2=::[CLX]Gantry_Y_Axis_FP
#3=::[CLX]Conveyor_Drive_FP
#4=::[CLX]Diverter_Drive_FP
#5=::[CLX]Diverter_Drive_FP
#6=::[CLX]Diverter_Drive_FP
#7=::[CLX]Diverter_Drive_FP
#8=::[CLX]Diverter_Drive_FP
#9=::[CLX]Diverter_Drive_FP
Startup
#1=::[CLX]
#2=::[CLX]WidgOmatic
StateDiagram #1=::[CLX]WidgOmatic
The Equipment Status faceplate requires that
parameters are set for all rows #1…9 even if they
are not visible. Typically, the last visible row
parameter is entered in the remaining
parameters. For example, Diverter_Drive_FP
parameter entered for #4…9.
Refer to Configure Equipment Status Faceplate
Display on
page 138 for more information.