Step 8 – Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start User Manual
Page 302
Advertising
302
Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013
Appendix G
Controller, Network, and Device Configuration Without the DMAT Wizard
8.
Click the Scaling category and edit the parameter default values as appropriate for your application.
9.
Click Apply, if you make changes.
10.
Click the Load category and edit the parameter default values as appropriate for your application.
11.
Click Apply, if you make changes.
Advertising
This manual is related to the following products: