Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start - Manual (Page 286)

286 Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013
Appendix G Controller, Network, and Device Configuration Without the DMAT Wizard
Set PowerFlex Drive Parameters
PowerFlex drive parameter settings are specific to your application and should be reviewed carefully before
running your drive application. In this procedure, you use the Startup Wizard to set the most commonly
configured parameters.
1. Right click the PowerFlex drive under I/O Configuration and choose Properties.
For the Widg-O-matic example, the PowerFlex 753 drive is selected.
The Module Properties dialog box opens.
2. Click the Drive tab.
The Drive tab dialog box opens.
3. Click (startup wizard).
The Startup Wizard provides access to commonly used parameter groups and helps you setup the drive for
the connected motor.
The Available Wizards dialog box opens.
4. Select the Startup Wizard and Click Select.
For the Widg-O-matic machine application
example, the PowerFlex 753 Startup Wizard
was chosen.
5. Click Yes when the Wizard Launch Confirmation dialog box opens.