Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start - Manual (Page 263)

Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013 263
Assemble Project Drawing Set Without the DMAT Wizard Appendix F
3. Copy the controller I/O drawings required for your specific application.
For the Widg-O-matic machine application example, all of the 1756 I/O drawings were selected.
4. Paste the drawings into your Project Drawings folder.
5. Repeat step 2 … step 4 for every unique controller in your system.
For the Widg-O-matic machine application example, the following controller I/O drawings were copied
to accommodate the 1756 ControlLogix controller I/O.