Follow these steps – Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start User Manual
Page 49
Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013
49
System Layout and Wiring
Chapter 3
Follow These Steps
Complete the following steps to create your system layout and wiring drawings. These steps provide general
instructions for how to maximize the use of the toolkit’s drawing library in creating a complete drives-and-
motion system layout and wiring drawing set. AutoCAD or AutoCAD Electrical software is recommended to
take full advantage of the drawing editing steps included in this chapter and the library’s device wiring references
and attributes that move with the devices as you edit your project drawing set. Some of the initial project creation
steps are illustrated using AutoCAD Electrical software, but most are generic and can be used with a variety of
software drawing packages.
If you chose not to use the DMAT Wizard, follow the instructions in
before executing the following
steps in this chapter.
Edit Drive, Controller, and Safety
Start