Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start - Manual (Page 235)

Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013 235
Appendix
D
Logix Designer Communication and Controller Configuration
In this appendix you configure your personal computer and controller communication, configure your
controller, and create a new project using the Logix Designer application.
Configure Personal Computer Communication Properties
In this section you set and verify the IP address of the personal computer running your program.
Set the IP Address
1. On your desktop, right-click My Network
Places and select Properties.
2. Double-click Local Area Connection.
3. On the General tab, select Properties.
4. Verify Internet Protocol (TCP/IP) is
checked and selected.
5. Click Properties.
6. Select Use the following IP address.
7. Enter the IP address and Subnet mask as
shown or enter your address.
8. Click OK.
9. Close all network windows.