Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start - Manual (Page 325)

Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013 325
Controller, Network, and Device Configuration Without the DMAT Wizard Appendix G
The Module Definition dialog box lets you configure and access drive data beyond standard I/O.
9. Configure module definitions.
a. Enter major and minor revisions appropriate for your drive hardware.
b. Enter drive rating appropriate for your drive hardware.
c. Set datalink definitions.
10. Click OK to save and close the Module Definition dialog box.
11. Click OK to save and close the New Module dialog box.
12. Verify your device configuration and save the file.
IMPORTANT The datalinks listed for the SMC-50 soft starter must be configured exactly as shown for successful faceplate AOI import
and operation. If additional datalinks are required for your application, modifications to the corresponding AOI can be
required.