Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start - Manual (Page 123)

Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013 123
FactoryTalk View ME Configuration Chapter 5
4. To create another parameter file based on an existing one, right-click the parameter file and choose
Duplicate.
For the Widg-O-matic machine application example, Gantry_X_Axis and Gantry_Y_Axis use the same
CIP_Motion_Faceplate, but require individual parameter files. For example, Gantry_X_Axis is duplicated
and renamed to Gantry_Y_Axis in
step 5 .
5. Rename the parameter file as needed for your application.
6. Click OK.
7. Repeat step 1 … step 6 for each device or logic module parameter file.
This is the completed Widg-O-matic renamed parameter file listing.