Before you begin, What you need, Appendix g – Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start User Manual
Page 269: Before you begin what you need, Lete, Appendix
Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013
269
Appendix
G
Controller, Network, and Device Configuration
Without the DMAT Wizard
In this appendix you configure your controller, network, and device hardware; then import the machine,
application, and device modules into your Logix Designer application without using the DMAT Wizard or
making edits after the initial file is created.
Before You Begin
•
Complete your system architecture and hardware selection (refer to
).
•
Complete your system layout and wiring (refer to
What You Need
•
The Drives and Motion Accelerator Toolkit DVD, publication
. For a copy of the DVD,
contact your local Rockwell Automation distributor or sales representative.
•
RSLogix 5000 software, version 18.0 or later, or the Logix Designer application, version 21.0 or later, for
Kinetix 300, Kinetix 6500, PowerFlex 753, and PowerFlex 525 drives.
•
RSLogix 5000 software, version 19.0 or later, or the Logix Designer application, version 21.0 or later, for
PowerFlex 755 CIP Motion drives.
•
RSLogix 5000 software, version 20.0 or later, or the Logix Designer application, version 21.0 or later, for
Kinetix 350 servo drives.
•
Sercos and Analog Motion Configuration and Startup User Manual, publication
•
CIP Motion Configuration and Startup User Manual, publication
•
ControlFLASH Firmware Upgrade Kit Quick Start, publication
•
The user manual for your Drives and Motion hardware. Refer to Additional Resources on
publication numbers.