Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start - Manual (Page 273)

Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013 273
Controller, Network, and Device Configuration Without the DMAT Wizard Appendix G
Configure the Ethernet Module
Follow these steps to configure Ethernet communication for your HMI terminal, PowerFlex drive, Kinetix 300,
Kinetix 5500, and Kinetix 6500 servo drives.
1. Expand I/O Configuration in the Controller
Organizer.
2. Right-click I/O Configuration and choose New
Module.
The Select Module dialog box opens.
3. Expand the Communications category and select
your 1756 Ethernet module.
For systems using Integrated Motion on the
EtherNet/IP network, 1756-EN2
x or 1756-EN3x
module are required.
In this example, the 1756-EN2TR module is
selected.
4. Click OK.
The New Module dialog box opens.
5. Configure the new module.
a. Type the module Name.
b. Enter the Logix5000 EtherNet/IP
module slot (leftmost slot = 0).
c. Select an Ethernet Address option.
In this example, the Private
Network address is selected.
d. Enter the address of your
EtherNet/IP module.
In this example, the last octet of the address is 10.
6. Click Change in the Module Definition area.