Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start - Manual (Page 284)

284 Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013
Appendix G Controller, Network, and Device Configuration Without the DMAT Wizard
This Module Definition example applies to PowerFlex 700S 2P datalinks.
This Module Definition example applies to the PowerFlex 4-class drives.
IMPORTANT The PowerFlex 4-class drives do not support datalinks. Therefore, the corresponding PowerFlex 4 faceplates do not require
datalink configuration.
IMPORTANT For PowerFlex 4-class drive configuration, in addition to checking Use Network Reference, you must also check Use
Network Start to control the drive from the Ethernet network port.