Add smc-50 devices to your logix designer project – Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start User Manual
Page 324
324
Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013
Appendix G
Controller, Network, and Device Configuration Without the DMAT Wizard
2.
Check the AOP for Drives-PowerFlex/SCANport profile.
3.
Click Download Now and accept the user license agreement.
If prompted to install the Download Manager, allow the installation.
4.
Click the Add-On Profile icon and follow the download instructions.
5.
Extract the AOP zip file and run MPSetup.
Add SMC-50 Devices to Your Logix Designer Project
Follow these steps to add each SMC-50 device in your system to the Logix Designer project file.
1.
Open your Logix Designer project file created in the previous section (for the Widgomatic example the
project file was named Widgomatic.acd).
2.
Expand the I/O Configuration folder in the Controller Organizer and browse to the controller backplane.
3.
Right-click the network communication module for your SMC-50 device and choose New Module.
The Select Module dialog box opens.
4.
Expand the Drives folder and select the
SMC-50 module.
5.
Click OK.
The New Module dialog box opens.
6.
Name the module.
7.
Enter the IP Address.
8.
In the Module Definition field, click
Change.
The Module Definition dialog box opens.