Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start - Manual (Page 173)

Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013 173
System Application Guide Chapter 7
Machine Startup Faceplate
The Machine Startup faceplate display provides general machine status and control. It is also configured as the
main navigation display for access to the other devices, the Alarm History faceplate display, and the Equipment
Status faceplate display.
Machine Status
The Machine Status indicators (OK and Faulted) provide general machine status (refer to the figure below). The
specific indicator functions are included in the Machine Status Indicators table on
page 174 .
In this example, there are seven Goto display buttons configured. There is one Goto display button for each of
the four drives, the State Diagram, the Equipment Status display, and the Alarm History display. Pressing any of
the Goto display buttons launch the associated display.
IMPORTANT If the Machine Startup display is not visible or errors are reported on either the Logix5000 controller or PanelView Plus terminal,
refer to previous chapters to check system wiring and configuration settings.
Drive Goto Display
Buttons
Machine Status Indicators
OK Status Machine Control Buttons
System Goto Display Buttons
Machine Status Indicators
Faulted Status
Abort Status Indicator
Exit HMI Application
Button