Function select: utility: system: remote address, Function select: utility: system: remote type, Function select: utility: system: operation mode – Comtech EF Data SDM-300A User Manual
Page 187
![background image](/files/778893/content/doc187.png)
SDM-300A Satellite Modem
Revision 6
Front Panel Operation
MN/SDM300A.IOM
5–93
FUNCTION SELECT: UTILITY: SYSTEM: REMOTE ADDRESS
REMOTE ADDRESS
1
Range: 1 to 255
The current modem address is displayed. To change the remote address, press [ENTER]. Press
[
↑] or [↓] to make the selection. Press [ENTER] to execute the change.
Note: Address 0 is reserved as a Global Address.
FUNCTION SELECT: UTILITY: SYSTEM: REMOTE TYPE
REMOTE TYPE
RS485 (2-WIRE)
EIA-485(2-Wire), EIA-485(4-Wire) or EIA-232
FUNCTION SELECT: UTILITY: SYSTEM: OPERATION MODE
OPERATION MODE
DUPLEX
DUPLEX, TRANSMIT ONLY or RECEIVE ONLY
Programs the modem for selected type of operation.
IMPORTANT
Note: When TRANSMIT ONLY or RECEIVE ONLY are selected, the
appropriate faults are masked from the Faults and Stored Faults menus.