Comtech EF Data SDM-300A - Manual (Page 443)

SDM-300A Satellite Modem Revision 6
Remote Control Operation MN/SLM3650.IOM
A–51
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
RF loopback
(ref. 'RFL_' command).
IF loopback
(ref. 'IFL_' command).
Sweep center frequency
(ref. 'SCF_' command).
Sweep width range
(ref. 'SWR_' command).
Sweep reacquisition
(ref. 'SR_' command).
BER threshold
(ref. 'BERT_' command).
Demodulator type
(ref. 'DT_' command).
Demodulator decoder type
(ref. 'DDT_' command).
Transmit clock source
(ref. 'TC_' command).
External reference frequency
(ref. 'ERF_' command).
Transmit clock phase
(ref. 'TCP_' command).
Receive clock phase
(ref. 'RCP_' command).
Baseband loopback
ref. 'BBL_' command).
Interface loopback
(ref. 'ILB_' command).
Interface loop timing
(ref. 'ILT_' command). p25 = n, where 'n' is '0' (off) or '1' (on).
p26 = n, where 'n' is '0' (off) or '1' (on).
p27 = snnnnn, sweep center frequency in Hertz.
p28 = nnnnn, sweep range in Hertz.
p29 = nnn, reacquisition time in seconds.
p30 = xxxx, BER threshold.
p31 = n, where 'n' is '0' (EFD), '1' (INTL), '3' (FDC), or '4'
(CSC).
p32 = n, where 'n' is '0' (SEQ), '1' (VIT), ‘2’ (Turbo)
p33 = n, where 'n' is '0' (INT), '1' (REF), '2' (EXT), or 6
(DATA).
p34 = nnnnn.n, external reference frequency in kHz.
p35 = n, where 'n' is '0' (NRM), '1' (INV), '2' (AUTO).
p36 = n, where 'n' is '0' (NRM), '1' (INV).
p37 = n, where 'n' is '0' (off) or '1' (on).
p38 = n, where 'n' is '0' (off) or '1' (on).
p39 = n, where 'n' is '0' (off) or '1' (on).