Comtech EF Data SDM-300A - Manual (Page 410)

SDM-300A Satellite Modem Revision 6
Remote Control Operation MN/SLM3650.IOM
A–18
ASYNC Transmit
Channel Stop Bits Command:
Response:
Status:
Response: <add/TCSB_n'cr'
>add/TCSB_n'cr''lf']
<add/TCSB_'cr'
>add/TCSB_n'cr''lf']
Where: n = 1 or 2 (stop bits).
Note: TX ASYNC Overhead only.
ASYNC Receive
Channel Stop Bits Command:
Response:
Status:
Response: <add/RCSB_n'cr'
>add/RCSB_n'cr''lf']
<add/RCSB_'cr'
>add/RCSB_n'cr''lf']
Where: n = 1 or 2 (stop bits).
Note: RX ASYNC Overhead only.
ASYNC Transmit
Overhead
Channel Parity Command:
Response:
Status:
Response: <add/TOCP_xxxx'cr'
>add/TOCP_xxxx'cr''lf']
<add/TOCP_'cr'
>add/TOCP_xxxx'cr''lf']
Where: xxxx = ODD, EVEN, or NONE.
Note: TX ASYNC Overhead only.
ASYNC Receive
Overhead
Channel Parity Command:
Response:
Status:
Response: <add/ROCP_xxxx'cr'
>add/ROCP_xxxx'cr''lf']
<add/ROCP_'cr'
>add/ROCP_xxxx'cr''lf']
Where: xxxx = ODD, EVEN, or NONE.
Note: RX ASYNC Overhead only.
ASYNC Transmit
Communica-
tions Type Command:
Response:
Status:
Response: <add/TCT_xxxxxxxx'cr'
>add/TCT_xxxxxxxx'cr''lf']
<add/TCT_'cr'
>add/TCT_xxxxxxxx'cr''lf']
Where: xxxxxxxx = RS232, RS485 (4- Wire),
RS485_2W (2-Wire).
Note: TX ASYNC Overhead only.
ASYNC Receive
Communica-
tions Type Command:
Response:
Status:
Response: <add/RCT_xxxxx'cr'
>add/RCT_xxxxx'cr''lf']
<add/RCT_'cr'
>add/RCT_xxxxx'cr''lf']
Where: xxxxx = RS232 or RS485.
Note: RX ASYNC Overhead only.
Transmit Data
Phase Command:
Response:
Status:
Response: <add/TDP_xxxx'cr'
>add/TDP_xxxx'cr''lf']
<add/TDP_'cr'
>add/TDP_xxxx'cr''lf']
Where: xxxx = NRM (normal data phasing),
INV (inverted data phasing).