Comtech EF Data SDM-300A - Manual (Page 417)

SDM-300A Satellite Modem Revision 6
Remote Control Operation MN/SLM3650.IOM
A–25
Mux
Tributary
Async
Format Command:
Response:
Status:
Response: <add/MTAF_x_yyy'cr'
>add/MTAF_x_yyy'cr''lf']
<add/MTAF_x'cr'
>add/MTAF_x_yyy'cr''lf']
Where:
x = 1 to 8 (tributary number).
yyy = 7E1, 7O1, 7N2, 7E2, 7O2, 8N1, or 8N2.
A.11 Flex Mux Configuration Commands (Flex Mux PCB Installed Only)
TX Channel
#1 Enable Command:
Response:
Status:
Response: <add/TCEN_1_xxxx'cr'
>add/TCEN_1_xxxx'cr''lf']
<add/TCEN_1'cr'
>add/TCEN_1_xxxx'cr''lf']
Where: xxxx = OFF (Disabled), DI (D&I Enabled), T1E1
(T1/E1 Enabled).
TX Channel
#1 Data
Rate Command:
Response:
Status:
Response: <add/TCDR_1_xxxx.x'cr'
>add/TCDR_1_xxxx.x'cr''lf']
<add/TCDR_1'cr'
>add/TCDR_1_xxxx.x'cr''lf']
Where: xxxx.x = 1544.0 or 2048.0 kbps for T1/E1 operation.
N * 64.0 kbps for D&I operation.
TX Channel
#2 Enable Command:
Response:
Status:
Response: <add/TCEN_2_xxx'cr'
>add/TCEN_2_xxx'cr''lf']
<add/TCEN_2'cr'
>add/TCEN_2_xxx'cr''lf']
Where: xxx = OFF (ADPCM Disabled), ON (ADPCM
Enabled).
This command enables channel #2 for ADPCM operation,
or can be disabled.
TX Channel
#3 Enable Command:
Response:
Status:
Response: <add/TCEN_3_xxxx'cr'
>add/TCEN_3_xxxx'cr''lf']
<add/TCEN_3'cr'
>add/TCEN_3_xxxx'cr''lf']
Where: xxxx = OFF (Channel Disabled), AUPC (Channel
Enabled for AUPC), A232 (Channel Enabled for ASYNC
RS232), S232 (Channel Enabled for SYNC RS232), A422
(Channel Enabled for ASYNC RS422), S422 (Channel
Enabled for SYNC RS422).
Note: This command enables channel #3 for SYNC/ASYNC
RS232/RS422 operation, AUPC operation, or can be
disabled.
TX Channel
#3 Data
Rate
Command:
Response:
Status:
Response: <add/TCDR_3_xxxx.x'cr'
>add/TCDR_3_xxxx.x'cr''lf']
<add/TCDR_3'cr'
>add/TCDR_3_xxxx.x'cr''lf']
Where: xxxx.x = 0.6 to 4000.0 for Sync. RS422 (kbps in 100
bit/s steps). 0.6 to 64.0 for all other modes (kbps in 100 bit/s
steps).