Comtech EF Data SDM-300A - Manual (Page 415)

SDM-300A Satellite Modem Revision 6
Remote Control Operation MN/SLM3650.IOM
A–23
AUPC
Maximum
Tracking
Rate Command:
Response:
Status:
Response: <add/MAXT_n.n'cr'
>add/MAXT_n.n'cr''lf']
<add/MAXT_'cr'
>add/MAXT_n.n'cr''lf']
Where: n.n = 0.5 to 6.0, in 0.5 increments (max tracking rate
in dBm/minute).
Note: ASYNC or AUPC Overhead only.
AUPC Local
Carrier Loss
Action Command:
Response:
Status:
Response: <add/LCL_xxxx'cr'
>add/LCL_xxxx'cr''lf']
<add/LCL_'cr'
>add/LCL_xxxx'cr''lf']
Where: xxxx = HOLD, NOM, or MAX (power level setting
when local carrier loss).
Note: ASYNC or AUPC Overhead only.
AUPC
Remote
Carrier Loss
Action Command:
Response:
Status:
Response: <add/RCL_xxxx'cr'
>add/RCL_xxxx'cr''lf']
<add/RCL_'cr'
>add/RCL_xxxx'cr''lf']
Where: xxxx = HOLD, NOM, or MAX (power level setting
when remote carrier loss).
Note: ASYNC or AUPC Overhead only.
A.9.2 Remote Modem AUPC Commands
Remote
Modem
AUPC
Commands
Notes:
1. Always wait 3 seconds between consecutive remote modem command/status polls.
2. If Local AUPC is not enabled, status commands will return last known condition. They will also request status
from the remote modem. This allows a second request to return proper status.
Remote
AUPC
Enable Command:
Response:
<add/RPC_xxx'cr'
>add/RPC_xxx'cr''lf']
Where: xxx = ON or OFF (remote AUPC enable).
Note: ASYNC or AUPC Overhead only.
Remote
Interface
Substitution
Pattern Command:
Response:
Status:
Response: <add/RISP_xxx'cr'
>add/RISP_xxx'cr''lf']
<add/RISP_'cr'
>add/RISP_xxx'cr''lf']
Where: xxx = ON or OFF (remote transmit 2047 pattern
enable).
Note: Transmit 2047 Pattern.
Remote
Interface
Baseband
Loopback Command:
Response:
Status:
Response: <add/RBBL_xxx'cr'
>add/RBBL_xxx'cr''lf']
<add/RBBL_'cr'
>add/RBBL_xxx'cr''lf']
Where: xxx = ON or OFF (remote baseband loopback
enable).
Note: ASYNC or AUPC Overhead only.