Comtech EF Data SDM-300A - Manual (Page 416)

SDM-300A Satellite Modem Revision 6
Remote Control Operation MN/SLM3650.IOM
A–24
Remote
Interface
Read Error
Status Command:
Response:
Example:
Command:
Response: <add/RRES_'cr'
>add/RRES_nE-e'cr''lf']
<add/RRES_'cr'
>add/RRES_2E-6'cr''lf'] Where:
n = 1 to 9 (error rate number).
e = 2 to 6 (exponent).
Note: Received 2047 Pattern.
This command returns 2047 BER from the remote AUPC
modem. If data is not valid, the message 'No_Data' is
returned in lieu of BER data.
A.10 MUX PCB Configuration Commands (MUX PCB Installed Only)
Mux
Tributary
Data Rate &
Enable Command:
Response:
Status:
Response: <add/MTDR_x_yyyyyy'cr'
>add/MTDR_x_yyyyyy'cr''lf']
<add/MTDR_x'cr'
>add/MTDR_x_yyyyyy'cr''lf']
Where:
x = 1 to 8 (tributary number).
yyyyyy = OFF (disabled), or 0.6 to 4000.0 (kbps in 100 bits
steps).
Mux
Tributary
Interface
Type Command:
Response:
Status:
Response: <add/MTIT_x_yyyyy'cr'
>add/MTIT_x_yyyyy'cr''lf']
<add/MTIT_x'cr'
>add/MTIT_x_yyyyy'cr''lf']
Where:
x = 1 to 8 (tributary number).
yyyyy = RS422 or RS232.
Mux
Tributary
Clock Phase Command:
Response:
Status:
Response: <add/MTCP_x_yyy'cr'
>add/MTCP_x_yyy'cr''lf']
<add/MTCP_x'cr'
>add/MTCP_x_yyy'cr''lf']
Where:
x = 1 to 8 (tributary number).
yyy = NRM (normal clock phasing), INV (inverted clock
phasing).
Mux
Tributary
Data Phase Command:
Response:
Status:
Response: <add/MTDP_x_yyy'cr'
>add/MTDP_x_yyy'cr''lf']
<add/MTDP_x'cr'
>add/MTDP_x_yyy'cr''lf']
Where:
x = 1 to 8 (tributary number).
yyy = NRM (normal data phasing), INV (inverted data
phasing).
Mux
Tributary
Mode Command:
Response:
Status:
Response: <add/MTMD_x_yyyyy'cr'
>add/MTMD_x_yyyyy'cr''lf']
<add/MTMD_x'cr'
>add/MTMD_x_yyyyy'cr''lf']
Where:
x = 1 to 8 (tributary number).
yyyyy = SYNC or ASYNC.