Errata b, Remote connector and pinouts (j6), Comtech ef data documentation update – Comtech EF Data SDM-300A User Manual
Page 4
Filename: T_ERRATA
1
Errata B
Comtech EF Data Documentation Update
Subject:
Correct RS reference in 4.1.1 Remote Connector and Pinouts (J6)
Date:
June 21, 2005
Document:
SDM-300A Satellite Data Modem Installation and Operation
Manual, Rev. 6, dated June 7, 2004
Part Number:
MN/SDM300A.EB6
Collating Instructions:
Attach this page to page 4-4
Comments:
Change paragraph 4.1.1 to read:
Change Specifics:
4.1.1 Remote Connector and Pinouts (J6)
The remote connector is a 9-pin subminiature female D connector (J6) located on the rear panel of
the modem. Screw locks are provided for mechanical security of the mating connector.
The remote connector interfaces the M&C functions to a remote location. The remote location can
be an M&C computer located away from the modem, but attached via cable to the remote
connector. This DCE interface is user selectable for either RS-232 or RS-485. Refer to Appendix A
for a description of the remote interface commands.