Comtech EF Data SDM-300A - Manual (Page 407)

SDM-300A Satellite Modem Revision 6
Remote Control Operation MN/SLM3650.IOM
A–15
Drop Data
Format Command:
Response:
Status:
Response: <add/DDF_xxxxxx'cr'
>add/DDF_xxxxxx'cr''lf']
<add/DDF_'cr'
>add/DDF_xxxxxx'cr''lf']
Where: xxxxxx = T1, T1ESF, E1CCS, E1CAS,
E131TS, T1S, or T1ESFS.
Insert Data
Format Command:
Response:
Status:
Response: <add/IDF_xxxxxx'cr'
>add/IDF_xxxxxx'cr''lf']
<add/IDF_'cr'
>add/IDF_xxxxxx'cr''lf']
Where: xxxxxx = T1, T1ESF, E1CCS, E1CAS,
E131TS, T1S, or T1ESFS.
Insert E1 CRC
Enable Command:
Response:
Status:
Response: <add/ICRC_xxx'cr'
>add/ICRC_xxx'cr''lf']
<add/ICRC_'cr'
>add/ICRC_xxx'cr''lf']
Where: xxx = ON or OFF.
Drop Channels
Assignment Command:
Response:
Status:
Response: <add/DCA_dd;cc'cr'
>add/DCA_dd;cc'cr''lf']
<add/DCA_dd'cr'
>add/DCA_dd;cc'cr''lf']
Where:
dd = 1 to N (over the satellite drop channel)
where N = (Modulator Data Rate) divided by
(64 kbps).
cc = 1 to 24 (terrestrial channel number for T1
data formats).
cc = 1 to 31 (terrestrial time slot number for E1
data formats).
Note: This command is not valid when the
drop data format is specified as E1CAS and
the modulator data rate is set to 1920.0 kbps.