Comtech EF Data SDM-300A - Manual (Page 442)

SDM-300A Satellite Modem Revision 6
Remote Control Operation MN/SLM3650.IOM
A–50
11
12
13
14
15
16
17
18
19
20
21
22
23
24
Scrambler enable
(ref. 'SE_' command).
Differential encoder enable
(ref. 'DENC_' command).
Modulator type
(ref. 'MT_' command).
Modulator encoder type
(ref. 'MET_' command).
Carrier only mode ON/OFF.
Demodulator IF
(ref. 'DF_' command).
Demodulator rate
(ref. 'DR_' command).
Demodulator preset A
(ref. 'ADRA_' command).
Demodulator preset B assignment
(ref. 'ADRB_' command).
Demodulator preset C assignment
(ref. 'ADRC_' command).
Demodulator preset D assignment
(ref. 'ADRD_' command).
Demodulator preset V assignment
(ref. 'ADRV_' command).
Descrambler enable
(ref. 'DE_' command).
Differential decoder
(ref. 'DDEC_' command).
p11 = n, where 'n' is '0' (off) or '1' (on).
p12 = n, where 'n' is '0' (off) or '1' (on).
p13 = n, where 'n' is '0' (EFD), '1' (INTL), '3' (FDC), '4'
(CSC), or '6' (SDM51).
p14 = n, where 'n' is '0' ( SEQ), '1' (VIT), ‘2’ (Turbo)
p15 = n, where 'n' is '0' (off) or '1' (on).
p16 = nnn.nnnnnn, demodulator IF frequency in MHz.
p17 = nnnn_mmmm.mmm, code rate/data rate in kbps.
p18 = nnnn_mmmm.mmm, code rate/data rate in kbps.
p19 = nnnn_mmmm.mmm, code rate/data rate in kbps.
p20 = nnnn_mmmm.mmm, code rate/data rate in kbps.
p21 = nnnn_mmmm.mmm, code rate/data rate in kbps.
p22 = nnnn_mmmm.mmm, code rate/data rate in kbps.
p23 = n, where 'n' is '0' (off) or '1' (on).
p24 = n, where 'n' is '0' (off) or '1' (on).