Fluke Biomedical medSim 300B - Manual (Page 33)

Operation
Panel Descriptions, Controls and Connectors
3
3-5
Cardiac Output
"CARDIAC OUTPUT" is optional. When installed, refer to the "Cardiac Output" chapter
for operating instructions.
Temperature—Variable and Fixed
For variable temperature selection, set the "CARDIAC OUTPUT/ VAR TEMP" switch to
"VAR TEMP" * , and adjust the temperature from the keyboard. Set the "PROBE" switch
to match the monitor probe type-400 or 700 ** .
Note
* "CARDIAC OUTPUT' is disabled in "VAR TEMP" mode.
** Temperature connector cables are available from Fluke Biomedical. The
type of probe simulated—either the 400 or 700 series YSI—determines the
type of cable to use.
Fixed temperature ("FIXED TEMP") is 37 °C/98.6 °F.
Blood Pressure
There are four blood pressure channels, labeled as "BP1", "BP2", "BP3" and
"BP4/AUX". Each channel is independently adjustable from the keyboard.
Set the "SENSITIVITY" switch to match the patient monitor's input sensitivity (either 40
or 5 µV/V/mmHg).
Note
To connect to the four blood pressure connectors, cables prewired for many
monitors, as well as an unterminated cable (see illustration "Unterminated
Blood Pressure Output Cable Assembly" at the end of this chapter), are
available from Fluke Biomedical. Refer to the medSim 300B Accessories
section in Chapter 1 and to the Fluke Biomedical Price List.
Respiration
• The respiration signal is output across the ECG leads.
• Corresponding with the type of patient monitor in use, set the "LEAD SELECT"
switch to the lead in use (I or II/RL-LL).
• Use the "BASELINE IMPEDANCE" switch to set the impedance (500, 1000,
1500, or 2000) between any two limb leads.
• Use the keyboard to set the respiration parameters.
Rear Panel
Battery Eliminator
The jack ("BATT ELIM 9 V DC") for the battery eliminator on the medSim 300B rear
panel. Use only a battery eliminator supplied by Fluke Biomedical.
Note
Refer to the medSim 300B Accessories section in Chapter 1 and to the
Fluke Biomedical Price List.