Verilink 9000 Series (34-00271) Product Manual - Manual (Page 90)

68 C HAPTER 4: NMCS
Port D Parameters The console port interface is an alternative to communicating with the MultiPro
unit through NMCS. Port D is the port labeled Supervisory on the rear panel of the
MultiPro unit. An example of the Supervisory screen is shown in Figure 4-18.
Line Module
This field indicates the line module number of the displayed port. Entering a
different line module number and pressing F10 transfer the program to the same
port on the new line module.
Port
The port field indicates the number of the displayed port. A different port may be
selected by entering its number here and pressing F10.
Description
This is a free-form field intended to describe the location or department this port
services.
Copy Port Parameters
The three fields on this line work together to allow copying an existing port
configuration to the current port.
Configuration. The number of the source configuration to copy from is entered in
this field. This can be any existing configuration, current or otherwise.
Line Module. Enter the line module number of the port to be copied.
Port. The number of the source port to be copied from is entered here.
TXPORT INTELLINET Configuration Program
Configuration 1000
Asynchronous TTY Console Port Parameters
Line Module [01] Port [5] Description [ ]
Copy Port Parameters from Configuration [ ] Module [ ] Port [ ]
Baud Rate [ AUTO] Bits per Character (7/8) [7]
Termination (DCE/DTE) (9200 only) [DCE] RTS/CTS Control (O/D/F) [D]
Parity (O/E/N) [E]
Full Duplex (Y/N) [Y]
Flow Control (X/D/C/N) [ X]
ESC=Main Menu F1=Help F5=Clear F7=Redisplay F8=Jump F9=Previous F10=Next
Figure 4-18 Asynchronous TTY Console (Supervisory) Port Parameters