Verilink 9000 Series (34-00271) Product Manual User Manual
Page 94
72
C
HAPTER
4: NMCS
LAN Speed
The LAN Speed parameter is used to configure the speed of the interface. In the
case of an Ethernet LAN, the value must be 10 Mbps.
Physical Port selection
The Physical Port Selection parameter specifies the interface type used by the
Ethernet driver. It may be the UTP (unshielded twisted pair) for an RJ-45 port or
AUI (attachment universal interface) for a DB-15 port.
Link Test Enabled
The Link Test Enabled parameter specifies whether or not the Ethernet driver
generates a link pulse. If this parameter is set to Enable, the bridge generates a
100-nanosecond pulse at a 15-millisecond interval. If set to Disable, no pulse is
generated.
Squelch Threshold
The Squelch Threshold parameter determines the voltage level the LAN link uses.
When using longer cables where attenuation is important, set this parameter to L
(lower). The default setting is N (normal).
Function Keys
ESC=Main Menu.
Returns to the main menu.
F1=Help.
Displays a help screen relative to the current field.
F5=Clear.
Clears the current field and place the cursor at the left-most position.
F7=Redisplay.
Redisplays the screen with the original data. Any data that was
changed on the current screen is lost.
F8=Jump.
Goes immediately to the access menu.
F9=Previous.
Moves one logical screen backwards.
F10=Next.
Moves one logical screen forward.
F9 and F10 write the current screen's fields to disk. Any information that changed is
saved at this time.
✍