Control wiring, Bypass field control wire landing, Fig 2.6 tb1 control terminal locations, all models – Yaskawa E7L Drive Bypass User Manual
Page 40
Advertising
Electrical Installation 2 - 8
Control Wiring
Bypass Field Control Wire Landing
The Bypass field control wiring is terminated on the control PCB A2, Terminal blocks TB1 through TB5. The terminal desig-
nations are labeled on the enclosure, adjacent to PCB A2 (see Figure 2.6). Route the control wiring as shown in Figure 2.5.
Fig 2.6 TB1 Control Terminal Locations, All Models
Advertising
This manual is related to the following products: