Yaskawa E7L Drive Bypass - Manual (Page 64)

Control Panel 3 - 8
Auto Run Status Indicator
Drive Ready Indicator
Auto/Rem Xfer Status Indicator
Damper/BAS Status Indicator
Table 3.13 Auto Run Indicator
Indicator Status Description
On (Green) The E7L is in AUTO mode and has received a Run command at TB1-2.
Off The E7L is not in AUTO mode or has not received a Run command
when in AUTO mode.
Table 3.14 Drive Ready Indicator
Indicator Status Description
On (Green) The Drive is ready to run or is running (no faults).
Off The Drive has a fault that will prevent operation.
Table 3.15 Auto/Rem Xfer Status Indicator
Indicator Status Description
On (Amber)
Auto Transfer to Bypass operation or Remote Transfer to Bypass
operation is active.
Off Auto or Remote Transfer to Bypass are not active (Auto Transfer may
be disabled by DIP switch S2-1).
Table 3.16 Damper/BAS Status Indicator
Indicator Status Description
On (Red)
A NC damper end switch or other BAS interlock contact at TB1-3 is
open.
Off This function is disabled by DIP switch S2-8 or a contact closure exists
between terminals TB1-3 and TB1-9.