Yaskawa E7L Drive Bypass - Manual (Page 76)

Control Panel 3 - 20
- VERIFY - Modified Constants (Parameters) Menu
Verify menu is used to display any parameters that have been changed from their default settings in a programming menu or by
autotuning. “None” will be displayed if no settings have been changed.
For the initialization parameters, only A1-00 will be displayed if it has been changed. Other initialize mode settings will not be
displayed even if they have been changed from their default settings.
In the verify menu, the same procedures can be used to change settings as they are used in the programming menus. Use the
INCREASE, DECREASE, and Shift/RESET keys to change the parameters. When the DATA/ENTER key is pressed after
changing the setting, the user parameter will be written into memory and the display will return to parameter monitor
automatically.
Example Operations
An example of key operations is given below for when the following settings have been changed from their default settings:
b1-01 (Reference Selection), C1-01 (Acceleration Time 1), E1-01 (Input Voltage Setting), and E2-01 (Motor Rated Current).
Fig 3.7 Operations in Verify Menu
Menu Selection Display Monitor Display Setting Display
Verify Menu Frequency reference
selection
Acceleration time 1
Input voltage setting
Motor rated current
Frequency reference
selection
Acceleration time 1
Input voltage setting
Motor rated current