Rainbow Electronics AT91CAP9S250A - Manual (Page 32)

32
6264A–CAP–21-May-07
AT91CAP9S500A/AT91CAP9S250A
• Two-pin UART
– Implemented features are 100% compatible with the standard Atmel USART
– Independent receiver and transmitter with a common programmable Baud Rate
Generator
– Even, Odd, Mark or Space Parity Generation
– Parity, Framing and Overrun Error Detection
– Automatic Echo, Local Loopback and Remote Loopback Channel Modes
– Support for two PDC channels with connection to receiver and transmitter
• Debug Communication Channel Support
– Offers visibility of and interrupt trigger from COMMRX and COMMTX signals from
the ARM Processor’s ICE Interface
9.12 Chip Identification
• Chip ID: 0x039A03A0
• JTAG ID: 0x05B1B03F
• ARM926 TAP ID: 0x0792603F
9.13 PIO Controllers
• 4 PIO Controllers, PIOA to PIOD, controlling a total of 128 I/O Lines
• Each PIO Controller controls up to 32 programmable I/O Lines
– PIOA has 32 I/O Lines
– PIOB has 32 I/O Lines
– PIOC has 32 I/O Lines
– PIOD has 32 I/O Lines
• Fully programmable through Set/Clear Registers
• Multiplexing of two peripheral functions per I/O Line
• For each I/O Line (whether assigned to a peripheral or used as general purpose I/O)
– Input change interrupt
– Glitch filter
– Multi-drive option enables driving in open drain
– Programmable pull up on each I/O line
– Pin data status register, supplies visibility of the level on the pin at any time
• Synchronous output, provides Set and Clear of several I/O lines in a single write