ABUS TV3220 - Manual (Page 10)

ABUS VMS ABUS Security-Center GmbH & Co. KG
System manual
Version 7.3 10
1.1 Starting the software
When the software starts, double-click the program icon on your desktop.
When the system first starts, it must be set
up for recording.
The set-up wizard appears. This will assist
you when setting up the system for the first
time.
1.1.1 The setup wizard
If your system has a video grabber card installed
(TV3300-3314 or TVVR95000-TVVR95020), the setup
wizard first configures the analog cameras.
Here you have the option of choosing the cameras that
will be used during operation. You can also select the
camera recording mode. The options here are:

None (the camera only shows live images)

Permanent (the camera images are permanently recorded)

Motion (the camera images are only recorded when motion is detected)
Make the settings are required and click Next.
The next window is for setting up IP cameras. First,
the program looks for all the IP cameras in the
system and lists them in a table.
If your IP camera is not listed, make sure that the
camera is in the same network and has been
assigned a valid IP address. If necessary, click
Search to perform the search again.
ABUS.® VMS