ABUS TV3220 - Manual (Page 110)

ABUS VMS ABUS Security-Center GmbH & Co. KG
System manual
Version 7.3 110
3.5.6 CASA10010
You can connect wireless components to the VMS software using the IP alarm module
(CASA10010). The following is an overview of the number of modules that can be connected
to the VMS software.
You can use the ABUS IP Installer to identify the IP address of the IP alarm module. Set the
connection in the IP alarm module to “Secvest IP” to complete the preparations for setting it up
in the software.
T hen click “Save + apply” to complete the setup. You can now use two alarm inputs or outputs
in the software.
Make sure the wireless components have been correctly taught in the IP alarm module. To
use the wireless outputs, put them into teach mode and then select output group 1 or 2 to
confirm.
3.6 Security settings
New users can be added and the system access for each individual user can be configured in
the security settings.
In addition, logged-in users can be automatically logged out and existing network connections
can be disconnected after a specific time.
Further information on the individual configuration points can be found below.
Software Basic Professional Enterprise
Number
1 2 4