ABUS TV3220 - Manual (Page 123)

ABUS VMS ABUS Security-Center GmbH & Co. KG
System manual
Version 7.3 123
3.7.4 Changing the network port
The network port may be changed in
order to operate multiple recorders via a
router (port forwarding). Because the
router can only forward a network port to
a single IP address, the port has to be
modified in order to control several
recorders.
This is done using the system
configuration. To change the network
port, open the system configuration and
move the selector to Network (item 5).
Select TCP/IP from the list on the left.
Enter the network port to be used in the TCP Port field and save the settings.
Then click Apply.
The configured network port is now used by the software.
Note that you must also specify this network port when creating a new host.
For existing hosts, you must add the network port to the IP address or URL. For more
information see section 3.7.3 on page 121.
From version 7.0 onward, you can configure and enable the web interface port here. By
default, Port 80 is used and enabled. To enable access to the recorder system, forward the
corresponding port in the router and install the VMS web interface on your recorder system.
For version 7.1 and up, you can log your VMS system onto the ABUS server. This requires a
valid account on the ABUS server. Enter your user data and click Save and Apply.
In order to ensure that the VMS and web interface ports work, forward both ports in your router
beforehand.