ABUS TV3220 - Manual (Page 51)

ABUS VMS ABUS Security-Center GmbH & Co. KG
System manual
Version 7.3 51
3.2 Camera configuration
The camera configuration is used to define the global settings of each individual camera and
also to add and set up new cameras. The camera configuration can be accessed over point 1
of the view switch (slider).
Descriptions of the individual configuration methods for analogue, IP and pan/tilt cameras can
be found below.
3.2.1 Setting up an analogue camera
Using the set-up wizard, the maximum available number of cameras is determined and
entered in the system configuration.
To be able to use more cameras in the software, the signal must first be connected to the
system using a BNC cable. The set-up can be continued if this has already been made.
Switching on the camera:
Open the system configuration and switch the view switch to the Camera view
(point 1). All analogue cameras are now listed on the left-hand side under TV33xx
camera.
Select the desired camera number and activate it using the On/Off field. The
camera number corresponds to the number on the BNC connection cable.
If a pan/tilt camera is connected, then it must be triggered according to point 3.2.2.
Using the On/Off field, only connect the cameras that are physically connected to
the system. Cameras which are not connected or activated can lead to
unintentional errors.