ABUS TV3220 User Manual
Page 100
ABUS VMS
ABUS Security-Center GmbH & Co. KG
System manual
Version 7.3
100
If the desired detector is not listed, then it may have to be activated first. Further information
on activating detectors can be found under point 3.5 on page 102.
2. Defining the start behaviour:
The start behaviour must be defined after selecting the detector. There are three different
parameters available here:
Off (process not started when the detector is triggered)
OK (process started as soon as the detector is switched on
– “OK status”)
Alarm (process started as soon as the detector is triggered
– “Alarm status”)
In most cases, the “Alarm” status is used. The “OK” status is usually only used in “BGV-
Kassen” mode.
5.
Define the start behaviour
6.
Select the timer
7.
Select the camera
8.
Connect the process
9.
Select the archive or notification
11. Save and apply
10. Define the priority