ABUS TV3220 - Manual (Page 83)

ABUS VMS ABUS Security-Center GmbH & Co. KG
System manual
Version 7.3 83
Select the host to be used by checking the box next to the host in the list. A multiple
selection of hosts is also possible here.
Click on the List button and select the desired camera(s). These are then used later in
the process. Add the cameras to the list on the right by double-clicking on them and
close the window by pressing OK. If more than one camera has been selected, then
the speed of camera display can be influenced using the Switch time field.
Now select the permission level. If you have set
up your own permission level, then this should be
selected here.
Otherwise, you can use the SuperVisor
permission level. Please note that a user-defined
permission level must also exist on the host with
the same permissions and the level name on both
systems must be identical. Otherwise, no
connection can be established to the host.
The start behaviour of the guard tour must then be set. When this is started over an
alarm detector, then the Hold entire duration/no. of images option must be selected so
that the process is completed, even when the detector is only triggered for a short
time.
When the process is started over a permanent alarm in connection with a timer, then
the start behaviour must be set to As long as detector unchanged, as a Permanent
alarm detector can never change its status.
2. Assign a name
1. Create a new process
3. Select the host
4. Select the cameras
5. Select Hold entire duration
6. Select the Disconnect option
7. Save the settings
Select the cameras by double-clicking
them.
>>