ABUS TV3220 - Manual (Page 60)

ABUS VMS ABUS Security-Center GmbH & Co. KG
System manual
Version 7.3 60
3.2.6 Displaying a camera name in the live image
The name of the activated camera can be shown in the live image. This makes it easier to see
which name is assigned to which image.
Open the system configuration and switch the view switch to the Camera view (point 1) .
Select the desired camera and check the Display
name in image box.
Save the settings and click on the Apply button.
After all settings have been loaded, the camera
name is shown in the live image when the
camera is activated.
3.2.7 Saving reference images
Reference images are used to compare the current image section of each camera with the
image created when the camera was first put into operation (does not apply to ABUS VMS
Basic).
In this way, alterations to the camera (manipulation, misplacement etc.) can be detected
swiftly and dealt with accordingly.
Before the camera can create a reference image, the relevant system support options must be
activated. Reference images can then only be created using these cameras.
To activate the reference image
system support, open the system
configuration and switch the view
switch to the Camera view.
Select the camera (analogue or
IP) from the list on the left and
check the Reference box.
Save the settings and click on
the Apply button.
The system shows whether a
reference image has already
been created by the camera on
the right-hand side of the camera
configuration page.
1. Select the Camera view
2. Select the desired camera
3. Activate the reference image system support
4. Save and apply
1. Select the Camera view
2. Activate the “Display name in image” box
3. Save and apply the settings