ABUS TV3220 - Manual (Page 54)

ABUS VMS ABUS Security-Center GmbH & Co. KG
System manual
Version 7.3 54
3.2.2 Setting up a pan/tilt camera
Important!
Pan/tilt cameras are usually triggered using the RS-422 or RS-485 bus (data transfer). In this
case, an additional converter is required (e.g RS-232

RS-422/485 or USB

RS-422/485).
Connected cameras are always set up as fixed cameras when activated during system
configuration. To add a pan/tilt function to a fixed camera, the pan/tilt support must be
activated.
To do this, switch on the pan/tilt support for the
desired camera in the system configuration
(Camera configuration

TV33xx camera

TV33xx camera 01

Pan/tilt).
Define the appropriate protocol, ID, interface
and position at disconnection. The appropriate
information can be found in the camera
documentation.
When all settings have been made, they must
be saved and then applied. Use the Save and
Apply buttons to do this.
The camera can now be controlled over the user interface using the joystick.
If this is not the case, then an excessively high baud rate may be the cause. Adjust the baud
rate according to your camera documentation (step 3) and then check the functionality again.
When using a pan/tilt network camera, the IP Camera Unit type and HTTP interface should be
selected in the pan/tilt configuration.
The availability of this setting depends on the successful set-up of an
IP camera. See the following description for more details.
1. Activate the pan/tilt function
2. Make the settings
3. Adjust baud rate (if necessary)