ABUS TV3220 - Manual (Page 67)

ABUS VMS ABUS Security-Center GmbH & Co. KG
System manual
Version 7.3 67
To create the first zone, move the slider in the Tool field to Zone 1 and draw the zone by
setting the corner points in the preview image (see section 3.2.8.1 on page 63).
Repeat these steps for Zone 2 (yellow mask) and Zone 3 (green mask).
As soon as you have drawn the zones in the preview image, a new
motion detector is created for each zone under Digital I/O

Detectors/block locks

Motion detection .
These detectors can then be linked to the required processes on the
activation screen (Processes

Activations).
In order to make it easier to assign the detectors, these have been
subordinated to the main motion detector (in this case Camera 06
MD).
Note:
The detectors (e.g. Camera 06 Zone 1 to Zone 3) are only triggered when motion is detected
in their zone. However, the main motion detector, Camera 06 MD, is always triggered.
For the main motion detector it is unimportant whether the movement is inside or outside a
zone: it always applies to the whole video image.
If, for example, an alarm is triggered in Zone 2, the detectors Camera 06 MD and Camera 06
Zone 2 are given Alarm status.
3.2.9 Setting up camera groups
Camera groups are used to group together cameras which belong together. This makes the
addition of cameras to the live window significantly easier, as the cameras no longer have to
be searched and activated individually. Instead, this can be made in one single step.