ABUS TV3220 - Manual (Page 11)

ABUS VMS ABUS Security-Center GmbH & Co. KG
System manual
Version 7.3 11
Activate the cameras for displaying and recording by selecting the checkbox in the ID field of
each camera.
If a user-defined password is used for the camera,
you are prompted to enter the user name and
password for the camera in order to activate it. There
is also an audible signal.
Only when authentication is successful can the
camera be used and the check mark appears in the
ID field.
You can now define the recording mode for the
camera in the Recording column. However, you can
only select no recording or permanent recording here.
If you want to record after motion is detected, you must select this later in the system
configuration (see section 3.2.3 on page 55), because motion detection first has to be
activated using the camera’s web interface. You will find more information on this in the
instructions for the camera.
Once you have completed the network camera configuration, click Next.
Note:
Pan/tilt network cameras are detected automatically. If one of these cameras was selected
during setup, the pan/tilt function is available as soon as you log in
Next, you must define the storage drives. Choose the
required storage drives by clicking the checkboxes
next to them.
The size of the archive is then automatically
calculated for all the activated cameras. The
calculation is based on the following formula:
2/3 of the configured memory space / number of
configured archives
For example, if you set up 16 archives and 250 GB of memory space is available, the
calculation is as follows: (2/3 * 250) / 16 = ~ 10.5 GB per archive
If you want to add more storage drives later or change the size of the archive, you can do this
easily using the system configuration. Then click Next.
In the subsequent dialog you can create the users. However, you can only have one user for
each authorization level.
The standard authorization levels Supervisor, Operator and Guest have the following
privileges: