ABUS TV3220 - Manual (Page 93)

ABUS VMS ABUS Security-Center GmbH & Co. KG
System manual
Version 7.3 93
3.4.6 Creating a video output process
Each video card has at least one video output. The video output can be controlled using three
different modes.
These are as follows:

Activity detection (camera is displayed when activity is detected)

Manual (currently selected camera is displayed on video output)

Sequencer (set cameras are displayed on the video output individually after a
defined switching time)
Setting up a process:
Open the system configuration and switch the view switch to the Actions view (point 3).
Select Video Output from the list on the left and create a new process using the New button.
Assign a unique name for the process. This makes it easier to find the process when
assigning the activation.
Specify the desired mode (activity detection, manual or sequencer) for the switching process
on the video output.
Select a video card to be used
for the process (for multi-card
operation only).
Define the video output to be
used.
Select the camera to be
displayed. Individual cameras
can be selected using semi-
colons or hyphens (e.g. 1-8;
10-12 or 1;3;5;7).
Define the switching time (in
sequencer mode only) and
save all the settings.
Switch the view switch in the system configuration to the Digital I/O view (point 2) and open
the Virtual alarm detector point.
Activate virtual alarm detector 20 (permanent alarm) and save the settings.
1. Select the “Actions” view
2. Create a new process
3. Assign a name
4. Define the switching process
5. Select the video card
6. Define the output
7. Define the cameras and switching time
8. Save the settings