ABUS TV3220 - Manual (Page 74)

ABUS VMS ABUS Security-Center GmbH & Co. KG
System manual
Version 7.3 74
3.4 Processes (actions)
Processes are used to prepare the system for new tasks. For example, the storage speeds for
recording can be set and notifications to external systems can be created using processes.
Any number of processes can be created in the ABUS VMS software. Ensure that the
individual components are given a clear and conclusive description. This makes it easier to
find existing configurations when adding new activations to the list at a later date.
The following pages describe how to create each of the individual processes.
3.4.1 Creating storage processes
Storage processes are used to store image data from analogue or IP cameras in the linked
archive. The image rate, resolution, compression or Stream1/2 can be set individually here.
To create a storage process, open the system configuration and switch the view switch to the
Actions view (point 3).
The first point in the list on
the left shows the storage
processes. You can create a
process manually or use pre-
defined configurations here.
For example, if you wish to
create
a process for
recording using activity
detection, then this can be
set up by clicking on the
Activity detection button. The
image rate or resolution can
then be changed as required.
The behaviour of the storage
process can also be defined
here. If a connected detector
triggers an alarm, then the storage process can either run until the alarm stops again (“As long
as detector unchanged”) or can be processed completely (“Hold entire duration/no. of
images:”).
As of version 7.0, you can choose between Stream 1 (high resolution) and Stream 2 (low
resolution) for the recording.
You can also activate audio for each recording process, provided that the PCIe card or
network camera supports audio.
Defining the image rate, compression and resolution
Buttons for creating pre-configured
storage processes
Creating a new process