ABUS TV3220 - Manual (Page 32)

ABUS VMS ABUS Security-Center GmbH & Co. KG
System manual
Version 7.3 32
2.4.5 Saving camera positions (presets)
The presets can be used to save and call up specific positions for pan/tilt cameras. Presets
are saved by pressing and holding down a number key while preset mode is activated (see
Fehler! Verweisquelle konnte nicht gefunden werden.). You then receive confirmation on
the live image of the camera (e.g. Preset 1 has been set).
Note:
The message that the preset has been saved does not appear until the command has been
sent to the camera. This can sometimes take up to 10 seconds.
If you save more than nine presets, click the button to move to double-digit mode.
Then save the preset by pressing and holding the number key after entering the second digit.
Example – saving present number 12:
1. Activate pan/tilt camera
2. Define image section 3. Switch keyboard to preset
mode 4. Activate double-digit
mode
5. Enter first digit
6. Enter second digit and hold
down key
7. Confirmation of saved preset