Setting a permanent mask – ABUS TV3220 User Manual
Page 63
ABUS VMS
ABUS Security-Center GmbH & Co. KG
System manual
Version 7.3
63
Setting the second corner point
Setting the third corner point
Setting the first corner point
3.2.8.1 Setting a permanent mask
The permanent mask is for limiting the area
analyzed by the selected camera.
Movements that occur within this area are
ignored by the software and not used for
recordings.
To draw a permanent mask (red mask) in the
preview image, VMS version 6.8 and allows you
to make the mask simply by setting the corner
points. The area within these corner points is then automatically masked.
Left-click inside the preview image to set the first
corner point.
Then move your mouse to the second corner
point of the mask and set it by clicking the left
mouse button again. Repeat this for all the other
corner points. If you set a corner point in the
wrong place. simply click it to remove it. The
mouse pointer changes to the following icon.
When you have set all the corner points, you must connect the last point with the first one.
Only then is the mask created and saved. The mouse pointer changes to the following icon
when you close the corner points.
The following illustrations show in detail how to create a mask.
Permanent mask display
Drawing the mask