ABUS TV3220 - Manual (Page 30)

ABUS VMS ABUS Security-Center GmbH & Co. KG
System manual
Version 7.3 30
Working with the geometry tool:
The geometry tool is used for displaying the Quadratic, 1Plus and 2Plus views as well as
reflecting the current view.
If the geometry tool is in one of the corners of the live window, the Quadratic and 1Plus views
can be displayed with the camera puck.
If the tool is positioned in the centre and on the edge of the live window in the horizontal or
vertical plane, then the 2Plus view is shown. However, it is not possible to switch to 2Plus
mode from every view.
To activate the 2Plus view, proceed as shown in the illustration Displaying the 2Plus view.
The current view can be reflected by moving the geometry tool to the opposite side.
The 2Plus view can only be displayed from a symmetrical 1Plus view.
Reflecting the current view
Displaying the 2Plus view