ABUS TV3220 - Manual (Page 58)

ABUS VMS ABUS Security-Center GmbH & Co. KG
System manual
Version 7.3 58
3.2.4 Setting up the camera anti-swivel protection
In order to prevent manipulation of the
camera, an anti-swivel monitoring system
is installed in the ABUS VMS software
(not included in ABUS VMS Basic).
Using this function, the system can detect
camera movements and send an alarm to
another system or receiver.
To activate the anti-swivel protection, first
open the system configuration
and select the view of the camera where
this function should be activated.
In the Sensor system area, check the Misplace box and save the settings. The camera is now
prepared for anti-swivel protection.
In order for the system to also be able to start processes in the event of camera
misplacement, these processes (notifications, alarms etc.) always have to be connected to a
detector. The anti-swivel protection is equipped with a virtual alarm detector (camera position
wrong).
This detector is always triggered when a camera with activated anti-swivel monitoring is
misplaced.
To set up the detector, switch the view
switch to Digital I/O (point 2) in the
system configuration, then open the
“Detector/Key switch” menu point on
the left-hand side.
Select Virtual detector and activate
detector 12 (camera position wrong).
Save the settings.
Finally, this detector must be linked to
a process. For more information on
possible
configurations, see
point 3.4.9 on page 98.
Note:
Only cameras with activated “Misplace” checkboxes can trigger an alarm over the virtual alarm
detector.
2. Save the settings
1. Activate anti-swivel protection
1. Select the Digital I/O view
2. Select the virtual alarm detector
3. Activate detector 12
4. Save the settings